|
DURA SEAL™
Super Base Sealer
 PRODUCT
DESCRIPTION:
DURA SEAL™ Super Base Sealer is a water
borne, fast-drying, crystal clear sealer, specially formulated
to provide an outstanding base coat for Dura
SeaI™ 1000 Water Based Finishes.
DURA SEAL™ Super Base Sealer helps
prevent tannin discoloration.
PRODUCT USE:
SURFACE PREPARATION:
Natural Floors:
Sand according to NOFMA or NWFA recommendations. Finish sanding
with 120 or 150 grit screen. Do not use steel wool. Vacuum very
thoroughly, then tack with a very lightly water dampened cloth
to remove all dust.
Stained Floors:
Sand according to NOFMA or NWFA recommendations. Finish sanding
with 100 grit screen (80 grit if white stain is used). Do not
use steel wool. Apply stain following manufacturer's application
and dry time instructions, spot test for compatibility. Make sure
stain is thoroughly cured.
NOTE: If high solids stain is used, before top
coating, buff cured stain with a green synthetic pad, then tack
with a water dampened cloth for best leveling and adhesion.
APPLICATION:
Make sure material is at room temperature. Invert container several
times before each use. A synthetic bar applicator is recommended
for even application of product, although a synthetic brush or
lambs wool applicator may also be used. Best results are obtained
at ambient temperatures between 50°F and 90°F, and at
humidities below 80%.
1) Pour a 4-6" wide line of DURA SEAL™
Super Base Sealer along the starting wall. Go with the direction
of the floor or grain.
2) Pull the sealer with a clean, moistened applicator toward the
other wall with an angled, squeegee motion. As you approach the
wall, turn the applicator and pad out excess material parallel
to the wet edge. Feather all turns, stopping and starting points.
3) Allow Sealer to dry 1-2 hours before applying finish coats.
PRODUCT PROPERTIES:
| DRY TIME |
1-2 hours before applying finish
coats |
| COVERAGE |
Approximately 400-500 sq. ft.
per gallon |
| CLEAN UP |
Clean application tools with
warm water immediately after use |
| STORAGE |
Store at room temperature. Keep
from freezing. If frozen, warm to room temperature and mix
thoroughly before use |
PHYSICAL PROPERTIES:
| RESIN TYPE |
Styrene Acrylic |
| DENSITY (LBS/GAL) |
8.65 |
| % SOLIDS |
33.0 |
| VISCOSITY - CPS |
75.0 cps (max.) |
| pH |
4.0 |
| VOC (g/I) |
Less than 250 grams/litre or
2.1 lbs/gal |
| FLASH POINT |
Greater than 200°F - Seta
Flash |
HEALTH/SAFETY:
| HMIS RATING: |
|
| Health |
2 |
| Flammability |
0 |
| Reactivity |
0 |
WARNING:
Avoid contact with skin and eyes. Wash thoroughly after use.
KEEP OUT OF REACH OF CHILDREN.
DO NOT TAKE INTERNALLY.
| Size |
SKU # |
Case/Pack |
| GAL |
80511 |
4 |
1/26/01
lit # DS990029
|
