08110 - STEEL DOORS AND FRAMES ARCAT SpecWizard

1. Configure Steel Door Institute - STEEL DOORS AND FRAMES:

Frames

Interior Frames:

Level 1 Standard Duty-Use With:

Level 2 Heavy Duty-Use With:

Level 3 Extra Heavy-Duty-Use With:

Exterior Frames:

Level 1 Standard Duty-Use With:

Level 2 Heavy Duty-Use With:

Level 3 Extra Heavy-Duty-Use With:

Level 4 Maximum-Duty-Use With:

Note: If Galvanized Frames are Required, Select One of the Two Following Methods of Indication for Location

Provide units of galvanized steel where indicated on the door schedule

Provide units of galvanized steel in the following locations

Exterior openings, as noted on door schedule

Kitchens, as noted on door schedule

Toilets, as noted on door schedule

Washrooms, as noted on door schedule

Locker rooms, as noted on door schedule

Showers, as noted on door schedule

Laboratories, as noted on door schedule

Frame Construction:

Slip-on drywall frame anchors shall be as provided by the manufacturer to assure performance specified

Borrowed or Sidelights Required - Provide glazing stops and beads where glazed lights are indicated

Doors

Interior Doors:

Level 1 - Standard Duty 1-3/8 inches (34.9 mm):

Level 1 - Standard Duty 1-3/4 inches (44.5 mm):

Level 2 - Heavy Duty 1-3/4 inches (44.5 mm):

Level 3 - Extra Heavy-Duty 1-3/4 inches (44.5 mm):

Level 4 - Maximum-Duty 1-3/4 inches (44.5 mm):

Exterior Doors:

Level 1 - Standard Duty 1-3/8 inches (34.9 mm):

Level 1 - Standard Duty 1-3/4 inches (44.5 mm):

Level 2 - Heavy Duty 1-3/4 inches (44.5 mm):

Level 3 - Extra Heavy-Duty 1-3/4 inches (44.5 mm):

Level 4 - Maximum-Duty 1-3/4 inches (44.5 mm):

Decorative Door Faces: Provide textured or embossed steel faces as indicated

Face steel sheet shall meet at least one or more of the following requirements:

Level 1:

Level 2:

Level 3:

Level 4:

End Closure:

Provide louvers and vision lites where indicated on the Drawings in accordance with ANSI/SDI A250.8

Provide steel astragals where indicated on the Drawings or where required by the manufacturer or NFPA 80

Fabrication

Quality Assurance

2. When you are finished making selections:

Generate Spec:

Word

WP or

RTF