Roofing and Fall Protection Equipment
Meets OSHA Requirement 1926.502(b)
Garlock Safety Systems TurboRail system is the perfect solution for quickly constructing an OSHA-approved temporary leading-edge fall prevention solution.
The heart of the system is our versatile Combo Clamp for vertical surfaces like parapet walls. The heavy-duty zinc plated clamp has a clamping range from 6.5" to 24.5", is adjustable in height, and accepts different stanchions. If the parapet won't accept the clamp, separate the clamp into its two parts and one side becomes a screw-down bracket that is attached with lag bolts.
The posi-lock button lock stanchion is our most popular solution. It accepts loop-end rails that quickly and easily snap into place to create the top rail or mid rail. The loop-end rails are compact and take up little storage space between jobs. These reusable rails are a far greener solution than wasting 2 X 4 lumber and takes less time to construct a railing system.
Or choose the combination stanchion that accepts either loop-end rails or 2 X 4 lumber. We also offer a dedicated 2 X 4 stanchion for the job site provided 2 X 4 lumber.
If one prefers to use our GuardRail 200™ preformed rails, the Combo Clamp and preformed rail adapter is needed. The adapter has two ports to accept the rail legs. The rails can be adjusted in height to meet the OSHA height requirement.
Meets OSHA Requirements1910.29(b)and 1926.502(b)
For more than 35 years, RailGuard 200 mobile safety rail and bases have been protecting the leading edge on rooftops. Its weighted, non-penetrating design makes it the perfect solution for permanent mounting and for temporary protection during roofing work or general construction.
It's 4-post design makes it easy to choose which port to use to get the best fit and spacing on the roof. Built-in two lifting handles make it easy to move around the roof.A wide range of options and accessories are available to accommodate any unique situation that may exist on your rooftop.
Meets OSHA Requirements 1926.502(b)(3) and (b)(4) and 1910.29(b)(3) and (b)(4)
Available in safety yellow and in widths from 4' to 12' in one-foot increments, the freestanding swing gate is designed to provide access through a section of Guardrail 200 railing.
On a rooftop, it can be used to provide an opening in the guardrail system where materials can be lifted and placed on the roof. Because it is not a two-gate system, appropriate safety measures must be used such as being tied off to an anchor point when the gate is open and the fall edge is exposed.
It can also be used where it is not possible or desirable to permanently mount a gate with anchors. Take a dock door as an example. Rather than drilling into the concrete and installing anchors, non-penetrating weighted bases are used to support the hinge post and latch post.
Meets OSHA Requirement 1926.501(b) (4)
Garlock Safety System's HatchProtector is the perfect solution for keeping employees and contractors alike; safe when on your roof.
Customers prefer its compression fit, non-penetrating design which has no possibility of creating a leak in the roof or the hatch.
They have a wide adjustment range in both length and width eliminating precise measuring.
A color-matched self-closing EasyFit™ gate is included so the fall hazard is always protected without the worker even thinking about it.
Meets OSHA RequirementsCAL OSHA 3212 (b) and (e)and 1926.501(b) (4)
ScreenGuardTM skylight fall prevention kits provide a cost-effective, OSHA and CAL OSHA fall prevention solution while retaining high light penetration.
ScreenGuard is non-penetrating so there are no screws or bolts that penetrate into the roof or the skylight itself so it cannot introduce leaks or void the warranty of the roof or skylight. It secures to the curb of the skylight with a tight compression fit.